Your welcome, Grant
| ausmini https://www.ausmini.com/forums/ |
|
| Pot Joint / Inner CV's https://www.ausmini.com/forums/viewtopic.php?f=2&t=68083 |
Page 1 of 1 |
| Author: | Boostedmini [ Thu Jan 06, 2011 3:34 pm ] |
| Post subject: | Pot Joint / Inner CV's |
Hi all, I have always used Hardy Spicer inner uni's but am looking to swap over to Pot Joints, I am running a Quaife ATB diff that has the smaller output shafts and i have the Swiftune output flanges to suit small spline outputs and the Hardy Spicers. anyway my question is can someone meaure the OD of the pot jont, i just want to ensure it will clear my massive exhaust downpipe off the turbo. thanks all Grant |
|
| Author: | GT mowog [ Thu Jan 06, 2011 5:22 pm ] |
| Post subject: | |
Funny you asked. I just measured one 2 minutes ago to make a puller. The OD of the steel outer is 3" exact and with sensible allowances for the boot will be 3 1/2". |
|
| Author: | Boostedmini [ Thu Jan 06, 2011 8:34 pm ] |
| Post subject: | |
too good GT, thanks for that info. Grant |
|
| Author: | GT mowog [ Fri Jan 07, 2011 6:30 am ] |
| Post subject: | |
Your welcome, Grant
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|