| ausmini https://www.ausmini.com/forums/ |
|
| Gearbox power loss https://www.ausmini.com/forums/viewtopic.php?f=2&t=68120 |
Page 1 of 1 |
| Author: | jb007 [ Sat Jan 08, 2011 9:49 am ] |
| Post subject: | Gearbox power loss |
Hi all. Have a 1310A+ that measured 51BHP at the wheel on a recent dyno day. I'm trying to calculated injector sizing for my EFI conversion project, http://www.ausmini.com/forums/viewtopic.php?t=67644, and need to know what the BHP would be at the engine. It is a standard A+ gearbox with 3.44 diff. Any ideas? 
|
|
| Author: | GT mowog [ Sat Jan 08, 2011 10:01 am ] |
| Post subject: | |
Without proper measurement it will only be an approximation, roughly in the range of 20% to 30%, however, do you have all the environmental factors of the day for corrections? These too can cause a variation of up to 40% easily. |
|
| Author: | Kennomini [ Sat Jan 08, 2011 11:21 pm ] |
| Post subject: | |
For an A series the general gestimate is 20-30% |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|