And if they do rust repairs all the better
| ausmini https://www.ausmini.com/forums/ |
|
| smash repairer https://www.ausmini.com/forums/viewtopic.php?f=2&t=68883 |
Page 1 of 1 |
| Author: | floss [ Wed Feb 16, 2011 9:22 am ] |
| Post subject: | smash repairer |
Hey, Wanting to know of a good smash repairer in the Melbourne area? Favour Fitzroy - footscray area sorta. DC |
|
| Author: | 3DJ [ Wed Feb 16, 2011 10:13 am ] |
| Post subject: | |
Hey i'll second that! I am also after suggestions for mini friendly panel beaters in the Melbourne metro areas |
|
| Author: | Fat Boy Dave [ Wed Feb 16, 2011 3:07 pm ] |
| Post subject: | |
And if they do rust repairs all the better
|
|
| Author: | Flute [ Wed Feb 16, 2011 3:57 pm ] |
| Post subject: | |
Just updated this other thread, similar subject. I found the blokes details but they have knocked off for the day so I will call tomorrow and make sure it is the same bloke and that he can still do minis. http://www.ausmini.com/forums/viewtopic ... 325#792325 |
|
| Author: | BALLISTIC [ Wed Feb 16, 2011 5:23 pm ] |
| Post subject: | |
I know its not in the area you guys are looking for, StyleRod Panels in Croydon is where my car was repaired and as far as i know are a reccommended Shannons repairer. http://www.whitepages.com.au/business/s ... rod+Panels http://www.google.com.au/#hl=en&biw=128 ... 9d2ae57967 hope this helps . . . . |
|
| Author: | Flute [ Wed Feb 16, 2011 8:57 pm ] |
| Post subject: | |
Thanks and hey, I hope you are going well. |
|
| Author: | sgc [ Wed Feb 16, 2011 10:53 pm ] |
| Post subject: | |
BALLISTIC wrote: StyleRod Panels in Croydon is where my car was repaired
I saw the aftermath of the accident on the Asparagus Job which caused the damage, and then the finished repair and I gotta say they did damn good work. Not a cut-it-out-and-weld-a-new-bit-in either, they beat the car straight and did a fine job. Not many places'll do that any more... |
|
| Author: | Flute [ Thu Feb 17, 2011 7:27 pm ] |
| Post subject: | |
Still waiting on a call back, it will be tomorrow now sorry.  Would be good to talk to the one above as well I think.
|
|
| Author: | Flute [ Fri Feb 18, 2011 3:28 pm ] |
| Post subject: | |
Just spoke to Steven Gaut of Melrose Panels, 27 Moore Road, Airport West, 9338 0633. He did the mini pictured in the link above and is happy to do more minis. Don't ask me what that one cost and Steven said he likes to go back to bare metal with bead or soda blasting. Not sure if he meant for full restos or minor repairs but you can discuss that with him if you want. I'm not saying this guy is the only or best in the area but I just know the car my mate had done came up really well and he was keen enough to do it well. I hope this helps. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|