| ausmini https://www.ausmini.com/forums/ |
|
| Rear stub axle dimensions and thread https://www.ausmini.com/forums/viewtopic.php?f=2&t=69120 |
Page 1 of 1 |
| Author: | Mister White Keys [ Mon Feb 28, 2011 10:23 am ] |
| Post subject: | Rear stub axle dimensions and thread |
Greetings all, I'm after any measurements people have got for the rear stub axle. The shaft diameters I am just wanting to cross check with what I've measured but I really need to find what thread is on the end of each axle. I understand that there is both a right hand thread and a left hand thread but what thread type, pitch etc. are these? Any help would be much appreciated, this is not for a mini but for a new project using mini hubs. Cheers, Steve |
|
| Author: | GT mowog [ Mon Feb 28, 2011 11:09 am ] |
| Post subject: | |
I'll be in the workshop a little later, I'll measure them for you. |
|
| Author: | GT mowog [ Mon Feb 28, 2011 3:28 pm ] |
| Post subject: | |
|
|
|
| Author: | 1018cc [ Mon Feb 28, 2011 3:32 pm ] |
| Post subject: | |
GTm, you may want to change the words in your picture, it states that both threads are LH threads 
|
|
| Author: | GT mowog [ Mon Feb 28, 2011 3:44 pm ] |
| Post subject: | |
1018cc wrote: GTm, you may want to change the words in your picture, it states that both threads are LH threads
Fixed, thanks |
|
| Author: | Mister White Keys [ Mon Feb 28, 2011 8:43 pm ] |
| Post subject: | |
Thanks heaps GT, thats exactly what I needed. Much appreciated Cheers, Steve |
|
| Author: | GT mowog [ Mon Feb 28, 2011 8:45 pm ] |
| Post subject: | |
Mister White Keys wrote: Thanks heaps GT, thats exactly what I needed.
Much appreciated Cheers, Steve It's nice to get a thanks, your welcome
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|