| ausmini https://www.ausmini.com/forums/ |
|
| Brake cylinders rear https://www.ausmini.com/forums/viewtopic.php?f=2&t=69429 |
Page 1 of 1 |
| Author: | Fiji [ Mon Mar 14, 2011 7:59 am ] |
| Post subject: | Brake cylinders rear |
Hey one of mine is leaking I am about 99% sure I have Cooper AP 7.5" discs. Which rear cylinders should I be using. From what I remember when I did this last there are 3/4" 5/8" cylinders. Spoke to someone this morning at Mspares & he mentioned 1/16" cylinders. Which ones guys? [/img] |
|
| Author: | 1018cc [ Mon Mar 14, 2011 8:19 am ] |
| Post subject: | |
For a disc brake front end you need 5/8" rear cylinders. 3/4" rear cylinders are for cars with drum brake front ends. 1/16" cylinders seem a bit small. I would think you may have misheard the measurement. |
|
| Author: | TK [ Mon Mar 14, 2011 9:47 am ] |
| Post subject: | |
I have some new quality QH brand cylinders here that are 5/8. $15 each. 3271 4616 or 0432 841 247 |
|
| Author: | michaelb [ Mon Mar 14, 2011 10:28 am ] |
| Post subject: | |
There is some usefull information on the Minispares UK website. Here is a brief cut and paste which may assist? ------------------------------------------------------------------------------------------------------- As a guide to start with, working suggestions I have used with reasonable success can be generally channeled into a few groups - *Discs with 4-pots and latest built-in servo and 7.5" discs with S-type servo, use GWC1131 -- 0.5625"(14.29mm) . *8.4" discs with or without servo, use GWC1126 -- 0.500"(12.7mm). *7.5" discs no servo use GWC1129 -- 0.6875"(17.46mm) . it's a working start. |
|
| Author: | Fiji [ Mon Mar 14, 2011 11:27 am ] |
| Post subject: | |
TK im in sydney & karkraft is just down the road but I'll let u know. Thanks Then I'm after the smaller 5/8" ones allowing more pressure to the Cooper discs I have. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|