thanks for the info!
you wouldnt happen to know where the thread is or who it was by as i have search for quite a while and cannot find
cheers
Nathan
| ausmini https://www.ausmini.com/forums/ |
|
| hydrolastic hoses https://www.ausmini.com/forums/viewtopic.php?f=2&t=69524 |
Page 1 of 1 |
| Author: | nathanm [ Thu Mar 17, 2011 7:19 pm ] |
| Post subject: | hydrolastic hoses |
Gday, been trying to chase up some hydro hoses for the front and back but have had no luck so i was wondering if any one would know where i could get some? Cheers |
|
| Author: | drmini in aust [ Thu Mar 17, 2011 7:23 pm ] |
| Post subject: | |
Some people have had Pirtek make them up. To fit them, a 1/8BSP thread needs to be cut on the spigot inside the displacer where the old hose is crimped on, then an adaptor fitting screwed on. There is a thread here somewhere with details. Nobody I know of can crimp new hoses straight into a displacer now as original, Dunlop used special tooling for that back then. |
|
| Author: | nathanm [ Thu Mar 24, 2011 8:23 pm ] |
| Post subject: | |
thanks for the info!
you wouldnt happen to know where the thread is or who it was by as i have search for quite a while and cannot find cheers Nathan
|
|
| Author: | Panthersteve [ Thu Mar 24, 2011 9:25 pm ] |
| Post subject: | |
Have a look here http://members.tripod.com/austin_america/id63.html , just scroll down the page a bit until you get to the repairing section. Cheers Steve |
|
| Author: | brett [ Thu Mar 24, 2011 10:57 pm ] |
| Post subject: | |
Buy them new from WWW.minispares.co.UK |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|