| ausmini https://www.ausmini.com/forums/ |
|
| Reinstalling pot drive shafts https://www.ausmini.com/forums/viewtopic.php?f=2&t=69801 |
Page 1 of 1 |
| Author: | mattsmadmini [ Wed Mar 30, 2011 12:37 am ] |
| Post subject: | Reinstalling pot drive shafts |
So i had to remove drive shafts from an engine the other day in order to transfer the engine into another subframe etc. Any who, i did the dirty thing and took the main pot boot off to slip them off (not the best decision i later learned) Regardless, thats where i am now, the pots are missing their inner bits, and one of the boots is shite and getting replaced. Is it a simple case of checking inner cages for all of their balls, packing with grease, sliding them back over pot, and doin up the zip tie thing? |
|
| Author: | miniobsessed [ Wed Mar 30, 2011 1:13 am ] |
| Post subject: | |
As long as the joint is not badly worn... Pretty much, yes. |
|
| Author: | GT mowog [ Wed Mar 30, 2011 4:04 am ] |
| Post subject: | |
Not sure how much of them you have lost but at least in regards to the factory ones, there are two 'sizes' of inner bits and they don't inter-change, so keep all the left bits left & the right bits right...... |
|
| Author: | mattsmadmini [ Wed Mar 30, 2011 8:05 am ] |
| Post subject: | |
not lost per say, a few of the balls fell out, i have a baggy of new ones that i was going to replace them all with anywho... Cheers Lads |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|