ausmini
https://www.ausmini.com/forums/

Aldi Engine Stands
https://www.ausmini.com/forums/viewtopic.php?f=2&t=70062		 Page 1 of 1
Author:  marc2131 [ Mon Apr 11, 2011 6:59 am ]
Post subject:  Aldi Engine Stands
Notice that Aldi supermarkets are selling engines stands for about $80. Are they worth it?
Would these hold a 1098?
Author:  mini1990 [ Mon Apr 11, 2011 8:20 am ]
Post subject: 
This was a special about 3-4 months ago. They sold poorly at the Aldi i work at so were sent elsewhere. Im assuming the stands you see at your Aldi are some leftovers.

Is it this model?:

http://www.aldi.com.au/au/html/offers/2827_16320.htm

Not sure about this or not but I dont think you can put an A series on it. Its
made for North-South engines with the gearbox mounted on the back.
Author:  michaelb [ Mon Apr 11, 2011 8:41 am ]
Post subject: 
The stand looks OK but you would need to have a mini engine mounting plate made up like I did for my Repco engine stand.
Author:  marc2131 [ Mon Apr 11, 2011 8:43 am ]
Post subject: 
mini1990 wrote:
This was a special about 3-4 months ago. They sold poorly at the Aldi i work at so were sent elsewhere. Im assuming the stands you see at your Aldi are some leftovers.

Is it this model?:

http://www.aldi.com.au/au/html/offers/2827_16320.htm

Not sure about this or not but I dont think you can put an A series on it. Its
made for North-South engines with the gearbox mounted on the back.


Thanks for that info. Thought it would fit directly. Wont buy it if that was the case.
Author:  Wombat [ Mon Apr 11, 2011 12:17 pm ]
Post subject: 
Could make good rotisserie ends if tall enough
Author:  Wombat [ Thu Apr 14, 2011 11:08 pm ]
Post subject: 
In Aldi at Chermside tonight - they had one reduced to $69
Author:  norton [ Fri Apr 15, 2011 3:49 pm ]
Post subject: 
there was one at Emu Plains marked down last week, might still be there
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/