Sits high but there is a copper washer under the shoulder against the banjo
| ausmini https://www.ausmini.com/forums/ |
|
| Electric pressure sensors for brake lights https://www.ausmini.com/forums/viewtopic.php?f=2&t=70250 |
Page 1 of 1 |
| Author: | mtsmini [ Thu Apr 21, 2011 12:35 pm ] |
| Post subject: | Electric pressure sensors for brake lights |
Re the electric sensor that sits on the drivers side in a bolt through a banjo in the engine bay. Is that sensor supposed to sit up proud or screw right down onto the top of the bolt? Mine's seems to sit high with a space between the bottom of the sensor and the banjo bolt. Meaning that the thread must be tapered? So: 1. It's supposed to screw down on top of the banjo bolt OR 2. It's supposed to sit up high. |
|
| Author: | Convertible Mini [ Thu Apr 21, 2011 1:14 pm ] |
| Post subject: | Brake lioght switch |
The brake light switch... If Brake lights work and switch or it's fittings don't leak... DO NOT TOUCH IT. |
|
| Author: | Wombat [ Thu Apr 21, 2011 1:15 pm ] |
| Post subject: | |
Sits high but there is a copper washer under the shoulder against the banjo
|
|
| Author: | mtsmini [ Thu Apr 21, 2011 1:34 pm ] |
| Post subject: | Electric pressure sensors for brake lights |
Its 9 to 10 I'm talking about. Rest is ok. Space is between 9 to 10. I note that there is no washer shown on the diagram. Never mind DON'T TOUCH IT. I've rebuilt my whole brake system including making up all the hard lines. It's just I thought that the sensor should sit down hard against the banjo but it doesn't want to. Either inside the bolt or the sensor thread must be tapered? |
|
| Author: | GT mowog [ Thu Apr 21, 2011 6:38 pm ] |
| Post subject: | |
The original switch sits high, not sure about replacements / aftermarket ones though. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|