| ausmini https://www.ausmini.com/forums/ |
|
| Aussie Patern Floors https://www.ausmini.com/forums/viewtopic.php?f=2&t=70259 |
Page 1 of 1 |
| Author: | crisonic [ Thu Apr 21, 2011 8:23 pm ] |
| Post subject: | Aussie Patern Floors |
Does any one know the date that the Aussie floor patern was introduced? It also had full length hydrolastic line covers on both sides of the car. I always thought it was a Mini K or Mk2 S intro but today I saw it on a Feb 68 Mk1 S and yes it was a genuine car with all matching numbers and all the correct bits . It was a shell that had been soda blasted and no - the floor had not been replaced Maybe I have always been wrong |
|
| Author: | simon k [ Thu Apr 21, 2011 8:34 pm ] |
| Post subject: | |
my guess is early '67 |
|
| Author: | Morris 1100 [ Thu Apr 21, 2011 8:51 pm ] |
| Post subject: | |
Definitely some time in 67 but I don't know exactly when. |
|
| Author: | micowen [ Thu Apr 21, 2011 9:26 pm ] |
| Post subject: | |
I'm just replacing a floor pan in my '67 deluxe. It has hydro lines running down both sides. |
|
| Author: | brett [ Thu Apr 21, 2011 10:44 pm ] |
| Post subject: | |
did you get an entire floor? or just the repair panels? |
|
| Author: | micowen [ Fri Apr 22, 2011 6:30 am ] |
| Post subject: | |
just the front passangers side brett. From front to back it has about an inch of the fire wall and finishes about an inch behind the box section that the seat mounts to. From side to side it has the entire inner sill and almost half the tunnel. |
|
| Author: | Mick [ Fri Apr 22, 2011 10:56 am ] |
| Post subject: | |
Agh the pleasure of having the right floor pan. The amount of hassle these panels save is a real pleasure... |
|
| Author: | kimini [ Fri Apr 22, 2011 11:16 am ] |
| Post subject: | |
Mick wrote: Agh the pleasure of having the right floor pan. The amount of hassle these panels save is a real pleasure...
Yup!! I bought new front and rear floors..............................about 12 months before the new hydro ones were available. Dammit   !
|
|
| Author: | Lindsay_Palmer [ Fri Apr 22, 2011 2:15 pm ] |
| Post subject: | |
Has anyone used the full front floor replacement panel yet? Like this one http://www.minisport.com.au/prod1857.htm. Sorry if this is a bit off topic. Is it just me or doesn't the tunnel look right, I think it is missing a small hump beside the tunnel. I want to replace the front floors in my project car with the correct floors (even though I replaced both front floors not that long ago with the only panels available at the time which are not correct). |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|