| ausmini https://www.ausmini.com/forums/ |
|
| Reskinning my door https://www.ausmini.com/forums/viewtopic.php?f=2&t=70400 |
Page 1 of 1 |
| Author: | min16i [ Thu Apr 28, 2011 9:02 pm ] |
| Post subject: | Reskinning my door |
Hi All, I've finally started to splash a bit of paint about. I'm in the middle of respraying the inside of my drivers door and the replacement skin I got after Christmas and was wondering if I should use some seam sealer when it goes back together or if I should give a good dose of fish oil or the like. Ian |
|
| Author: | michaelb [ Thu Apr 28, 2011 9:49 pm ] |
| Post subject: | |
When I fitted my new door skin I ran a bead of seam sealer around the edge in the join between the door skin and the door frame I hope this will seal the water out plus it will assist with bonding the skin to the door But I will still be spraying a lot of waxoil in the bottom of all panels |
|
| Author: | min16i [ Fri Apr 29, 2011 10:37 am ] |
| Post subject: | Reskinning |
Hi Micheal, That's what I'm going to do, can't have too much rust proofing. Ian |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|