I stripped my 1310 to a bare block on the weekend, and have extracted an unknown cam. It has no markings in the usual places.. so all I can supply is the lobe dimensions.

[Low = narrowest width of lobe, High = tallest width of lobe]


INTAKE:
Low - 0.97" / 24.6mm
High - 1.249" / 31.73mm

Cam intake lift = 0.297" or 7.13mm

EXHAUST:
Low - 1.009" / 25.66mm
High - 1.293" / 32.84mm

Cam exhaust lift = 0.28" or 7.18mm

It has 1/2 inch wide lobes, spider drive, and has "113" stamped into the timing chain nut end. I have not yet measured the duration.

Can anybody give me any info on this cam with the above numbers???

_________________
[NATHAN] -- Sold everything mini related and am back in big beautiful BMWs

Nearest I can recall-
Might be a Tighe 112? see profiles in here- http://tighecams.com.au/cars.htm

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.

well there you go... mine's a tighe 240 - we sent my head specs to them after we ported and flowed it, and they sent a cam back to suit it. Was awesome till the head cracked itself to uselessness

_________________
did I tell you that I won a trophy?