| ausmini https://www.ausmini.com/forums/ |
|
| Can anybody recognise this cam for me?? https://www.ausmini.com/forums/viewtopic.php?f=2&t=7072 |
Page 1 of 1 |
| Author: | supercharged 850 [ Wed May 11, 2005 4:51 am ] |
| Post subject: | Can anybody recognise this cam for me?? |
I stripped my 1310 to a bare block on the weekend, and have extracted an unknown cam. It has no markings in the usual places.. so all I can supply is the lobe dimensions. [Low = narrowest width of lobe, High = tallest width of lobe] INTAKE: Low - 0.97" / 24.6mm High - 1.249" / 31.73mm Cam intake lift = 0.297" or 7.13mm EXHAUST: Low - 1.009" / 25.66mm High - 1.293" / 32.84mm Cam exhaust lift = 0.28" or 7.18mm It has 1/2 inch wide lobes, spider drive, and has "113" stamped into the timing chain nut end. I have not yet measured the duration. Can anybody give me any info on this cam with the above numbers??? |
|
| Author: | drmini in aust [ Wed May 11, 2005 6:44 am ] |
| Post subject: | |
Nearest I can recall- Might be a Tighe 112? see profiles in here- http://tighecams.com.au/cars.htm |
|
| Author: | simon k [ Wed May 11, 2005 10:25 am ] |
| Post subject: | |
well there you go... mine's a tighe 240 - we sent my head specs to them after we ported and flowed it, and they sent a cam back to suit it. Was awesome till the head cracked itself to uselessness |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|