thanks Doc.was that $20 a piston or caliper? did they have the rubbers kit also? don't think the retaining clips need replacing or are these an item thats best replaced now while they're apart? so many questions
| ausmini https://www.ausmini.com/forums/ |
|
| cooper brake pistons https://www.ausmini.com/forums/viewtopic.php?f=2&t=71051 |
Page 1 of 1 |
| Author: | subwayseth [ Thu Jun 02, 2011 9:57 pm ] |
| Post subject: | cooper brake pistons |
can anyone tell me if the 7.5" brake pistons will fit the 7" Lockheed calipers? I know the 7" ones are 1.618". Also has anyone got any figure approximately of how much it would be to get some made up in stainless steel? |
|
| Author: | drmini in aust [ Thu Jun 02, 2011 10:17 pm ] |
| Post subject: | |
No they are different to 7.5s- smaller and lots shorter.. I think you can still buy them new, I bought 4 SS ones 12 months ago. Karcraft still lists them- p/no is 1030241. $20 ea approx. |
|
| Author: | subwayseth [ Thu Jun 02, 2011 10:31 pm ] |
| Post subject: | |
thanks Doc.was that $20 a piston or caliper? did they have the rubbers kit also? don't think the retaining clips need replacing or are these an item thats best replaced now while they're apart? so many questions
|
|
| Author: | drmini in aust [ Thu Jun 02, 2011 10:41 pm ] |
| Post subject: | |
subwayseth wrote: thanks Doc.was that $20 a piston or caliper? did they have the rubbers kit also? don't think the retaining clips need replacing or are these an item thats best replaced now while they're apart? so many questions
That is 1 piston only. You need 4 in total. Caliper kit per side (for 2 pistons) is 8G8587L/3, $6 approx. You need 2 kits. You also need the bridge seal between the 2 caliper halves, it's not listed so ask them. Not included in the kits. |
|
| Author: | subwayseth [ Thu Jun 02, 2011 10:48 pm ] |
| Post subject: | |
Thanks again Doc. Always full of great advice |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|