| ausmini https://www.ausmini.com/forums/ |
|
| PCV valve https://www.ausmini.com/forums/viewtopic.php?f=2&t=71064 |
Page 1 of 1 |
| Author: | Arianca tan [ Fri Jun 03, 2011 10:14 pm ] |
| Post subject: | PCV valve |
I just finished putting a pcv valve on my car. I think I did I correctly. Do I have to adjust anything, eg. Carbies, idle etc. Any tricks? Thanks. Getting ready for Hay. |
|
| Author: | drmini in aust [ Sat Jun 04, 2011 8:09 pm ] |
| Post subject: | |
Should be no adjustments needed, unless you have a Weber and have fitted the valve to one inlet port only. Then, it's usual to richen the idle mixture slightly on that side only. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|