| ausmini https://www.ausmini.com/forums/ |
|
| sand blasters in western sydney https://www.ausmini.com/forums/viewtopic.php?f=2&t=71070 |
Page 1 of 1 |
| Author: | nicholasatkins [ Sat Jun 04, 2011 1:40 pm ] |
| Post subject: | sand blasters in western sydney |
Hey. Just woundering if anyone on here has had any experiance with sand blasters around western sydney? thanks nick |
|
| Author: | 1310/71 [ Sat Jun 04, 2011 2:06 pm ] |
| Post subject: | |
Impact Glass Beading 9 Romford Rd Blacktown 9671 3306 Just off sunnyholt rd near the Triumph/Yamaha motorcycle dealer. He's done a bit of work for me over the years and will be getting more very shortly. No complaints. |
|
| Author: | GT mowog [ Sat Jun 04, 2011 2:48 pm ] |
| Post subject: | |
Depends on what sort of blasting your after. For glass and garnet, the guys that 1310/71 suggests ^, which is fine for heavier steels and rust etc. If your looking to have the paint removed from say a body, then I use Sydney Soda Blasters in Anvil Rd, Seven Hills. |
|
| Author: | 1970minik [ Sat Jun 04, 2011 8:30 pm ] |
| Post subject: | |
There is also another Soda Blaster on the corner of Chicago and Butterfield sts in Blacktown. He was cheaper than the one at Anvil St Seven Hills and he etch primes as well, Seven Hill didnt |
|
| Author: | adamstuart [ Sun Jun 05, 2011 1:02 am ] |
| Post subject: | |
1310/71 wrote: Impact Glass Beading
9 Romford Rd Blacktown 9671 3306 Just off sunnyholt rd near the Triumph/Yamaha motorcycle dealer. He's done a bit of work for me over the years and will be getting more very shortly. No complaints. +1 for Claude on Romford Rd. Top guy |
|
| Author: | norton [ Tue Jul 19, 2011 12:12 pm ] |
| Post subject: | |
so how did you go ? did you pick one ? |
|
| Author: | nicholasatkins [ Wed Jul 20, 2011 4:05 pm ] |
| Post subject: | |
Went with advanced soda blasting in blacktown. Did a good job and resonable prices has done a few minis too, was one next to mine when i picked it up. |
|
| Author: | adamstuart [ Wed Jul 20, 2011 4:40 pm ] |
| Post subject: | |
What did you pay, if you don't mind me asking? And was it inside, outside, underside and engine bay? |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|