| ausmini https://www.ausmini.com/forums/ |
|
| Fibreglass bonnet https://www.ausmini.com/forums/viewtopic.php?f=2&t=71074 |
Page 1 of 1 |
| Author: | knuts2au [ Sat Jun 04, 2011 7:53 pm ] |
| Post subject: | Fibreglass bonnet |
What are people using to hold there fibreglass bonnets down? The back has hinge mountings built in, but what is legal for the front? (Victoria) Any pic's? |
|
| Author: | Harley [ Sat Jun 04, 2011 8:00 pm ] |
| Post subject: | |
Bonnet pins are legal, but if you want a flush fit setup look at dzus fasteners. |
|
| Author: | slide [ Mon Jun 06, 2011 6:58 pm ] |
| Post subject: | |
Are they legal? I took the 4 pins off the f/g bonnet on my SD1 and attached it with flush fitting fasteners instead. The f/g bonnet on my Mini Van is still attached with 4 sliding type pins. I was going to replace these with flush types too, but if there's no legal ramifications having pins I may as well retain them. They certainly look the business. |
|
| Author: | Convertible Mini [ Tue Jun 07, 2011 4:54 am ] |
| Post subject: | Fibre Glass Bonnet Fixing |
Duct tape hold well too. Try the 3M stuff ! |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|