ausmini
https://www.ausmini.com/forums/

Is this a mistake?
https://www.ausmini.com/forums/viewtopic.php?f=2&t=71080		 Page 1 of 1
Author:  MG Rocket [ Sat Jun 04, 2011 10:06 pm ]
Post subject:  Is this a mistake?
This is in the workshop manual for the Morris 1100s motor.
Should this read 45 ABDC ?

Image
Author:  VulcanBB18 [ Sun Jun 05, 2011 7:25 am ]
Post subject: 
Yeah that's a typo, plenty of them in the hand-typed stuff from the sixties :)

cheers,
Author:  MG Rocket [ Mon Jun 06, 2011 7:11 pm ]
Post subject: 
Could some nice person post the correct intake valve closing time?
Author:  drmini in aust [ Mon Jun 06, 2011 7:17 pm ]
Post subject: 
Inlet closes 45° ATDC.
Cam has same timing, lift and duration as a Morris 1100 (or a Mk1S).
Not a real exciting cam these days, but they regrind good to something that gives better HP and torque. :P

Ooops my bad, I meant ABDC.. that'll teach me to not proofread!! :lol: :oops:
Author:  GT mowog [ Mon Jun 06, 2011 8:35 pm ]
Post subject: 
This is what it should say;-

Image
Author:  MG Rocket [ Tue Jun 07, 2011 4:16 pm ]
Post subject: 
Thanks guys.
You had me worried Doc 8) ......I went searching the net high and low and couldn't find a cam closing the inlet BBDC :lol:
I'm just trying to get my head around valve timing....slowly getting it.
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/