This is in the workshop manual for the Morris 1100s motor.
Should this read 45 ABDC ?

Yeah that's a typo, plenty of them in the hand-typed stuff from the sixties

cheers,

_________________
'72 Clubman Van - 1022cc, 295 head, 731 cam - Daily Driver
'69 Morris 1100 S - Dinged by a bus, in shed under repair
'64 Morris 1100 - Early 1100, long term project

Could some nice person post the correct intake valve closing time?

Inlet closes 45° ATDC.
Cam has same timing, lift and duration as a Morris 1100 (or a Mk1S).
Not a real exciting cam these days, but they regrind good to something that gives better HP and torque.

Ooops my bad, I meant ABDC.. that'll teach me to not proofread!!

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.

This is what it should say;-

_________________

Thanks guys.
You had me worried Doc ......I went searching the net high and low and couldn't find a cam closing the inlet BBDC
I'm just trying to get my head around valve timing....slowly getting it.