| ausmini https://www.ausmini.com/forums/ |
|
| Bearing cap question https://www.ausmini.com/forums/viewtopic.php?f=2&t=71850 |
Page 1 of 1 |
| Author: | doogie [ Thu Jul 14, 2011 6:24 pm ] |
| Post subject: | Bearing cap question |
I have just found 2 main bearing caps, both have N275 stamped into them, Could I assume they are for a 1275? Doogie |
|
| Author: | drmini in aust [ Thu Jul 14, 2011 7:58 pm ] |
| Post subject: | |
Measure across their bore, if over 2-1/8" yeah they probably are. |
|
| Author: | TheMiniMan [ Thu Jul 14, 2011 10:27 pm ] |
| Post subject: | |
the number stamped on them "Usually" ties in with the 3rd main cap &&& the block that they came off will (or should) have the same number stamped into it near/rear of the water-pump area |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|