vacuum supply for boosted brakes?
-Cam
| ausmini https://www.ausmini.com/forums/ |
|
| Thread in top of Manifold ? https://www.ausmini.com/forums/viewtopic.php?f=2&t=7284 |
Page 1 of 1 |
| Author: | kazjim [ Tue May 17, 2005 9:21 am ] |
| Post subject: | Thread in top of Manifold ? |
hey all, On the cast-iron inlet manifold (standard).. what is the thread on either end ? Sometimes it has a brass plug, but there is usually one open thread with a barbed fitting or somthing..... I'm wanting to put a Hobbs switch in there and need a 1/8BSP Female thread to put it into ..... Little help ? Cheers J |
|
| Author: | MiNi MuLiShA [ Tue May 17, 2005 1:08 pm ] |
| Post subject: | |
vacuum supply for boosted brakes? -Cam
|
|
| Author: | kazjim [ Tue May 17, 2005 1:34 pm ] |
| Post subject: | |
Yes, possibly.. but what is the actual thread ? I'm hoping its 1/8 BSP ..... J |
|
| Author: | MiNi MuLiShA [ Tue May 17, 2005 1:57 pm ] |
| Post subject: | |
ahhh sorry man, cant help ya... kevs the man 
-Cam
|
|
| Author: | Stuartminidlx [ Tue May 17, 2005 10:12 pm ] |
| Post subject: | |
kazjim are u using a standard inlet manifold for your turbo setup. if s did u have to remove a fairly large amount of material for the 1 3/4" carb |
|
| Author: | kazjim [ Wed May 18, 2005 10:02 am ] |
| Post subject: | |
Nope, Made a 3/4" thick spacer out of Plate steel and bored it 1 3/4" ...... no hassles there.... J |
|
| Author: | ausminis4u [ Wed May 18, 2005 10:17 am ] |
| Post subject: | |
it is a unf thread....... thats all i know, put a bolt with 7/16 head in there ( dont know thread size) |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|