Mine did the same thing when it wanted a new slave cylinder.
| ausmini https://www.ausmini.com/forums/ |
|
| Clutch issues https://www.ausmini.com/forums/viewtopic.php?f=2&t=73404 |
Page 1 of 1 |
| Author: | grey 64 [ Tue Oct 04, 2011 7:00 pm ] |
| Post subject: | Clutch issues |
After cruising in the 850 for 20mins it became impossible to select a gear without pumping the pedal first. Today i checked the adjustments and all looks to be in order. Any ideas? |
|
| Author: | Tombo [ Tue Oct 04, 2011 7:42 pm ] |
| Post subject: | |
Low fluid? |
|
| Author: | drmini in aust [ Tue Oct 04, 2011 7:43 pm ] |
| Post subject: | |
I set the stop screw on the cover when hot, as expansion of the gearcase etc tends to increase pedal free play. I like to have around 20mm or so freeplay at the pedal. What gap is then at the stop screw, I have NFI. Some gap = OK. |
|
| Author: | Speedwell Racer [ Tue Oct 04, 2011 7:52 pm ] |
| Post subject: | |
Mine did the same thing when it wanted a new slave cylinder.
|
|
| Author: | drmini in aust [ Tue Oct 04, 2011 7:57 pm ] |
| Post subject: | |
Yes the symptoms do indicate this ^^^ If you buy a new slave I would use the seal spreader out of the old one. Reason: new ones are wrong shape, don't spread seal, = seals don't last long... |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|