| ausmini https://www.ausmini.com/forums/ |
|
| need some advice on parts https://www.ausmini.com/forums/viewtopic.php?f=2&t=74367 |
Page 1 of 1 |
| Author: | min-E [ Sun Nov 27, 2011 9:11 pm ] |
| Post subject: | need some advice on parts |
ok need to know where I can get some tyres for my rims. 165/55/12. I have asked a few places and found none that can get em in yet. I also need hood lining so should I lean towards DIY or get it done professionally? I also need a few other bits and bobs inc flares. So the main question is... is it better to get most of this from OS or local. Cheers |
|
| Author: | adamstuart [ Sun Nov 27, 2011 9:15 pm ] |
| Post subject: | |
Doogie has mentioned a few times his trimmer made and installed a hoodlining around his rollcage quite cheaply - perhaps ask doogie who it was? He would be in sydney Also tyres, you could go to the yokohama HQ in silverwater - right near karkraft, or just buy from the UK |
|
| Author: | GT mowog [ Mon Nov 28, 2011 6:36 am ] |
| Post subject: | |
That is a bit of an odd sized tyre, can you go to a 175 or a 185? It will open up a lot more options. I bought some in a 175 recently. No one had them on the shelf, but next day, no worries. <EDIT> Dunlop do actually do a 165/55/12. SP Sport R7. PM sent. |
|
| Author: | michaelb [ Mon Nov 28, 2011 7:37 am ] |
| Post subject: | |
For your parts I would check out mini king and Karcraft. For tyres you could try Minisport in Adelaide or I usually get mine from Bob Jane, Falken. but I did buy some 12" Yokohamas from the UK once when they were on special. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|