ausmini
https://www.ausmini.com/forums/

Differential questions
https://www.ausmini.com/forums/viewtopic.php?f=2&t=74422
Page 1 of 1

Author:  coopar [ Wed Nov 30, 2011 3:38 pm ]
Post subject:  Differential questions

In the process of stripping and renewing subframe bits and pieces.
Im about to pull off the hubs, cvs etc.
On the end of the cv I currently have whats in the top of this pic. Rubber coupling?

Image

Whats the best driveshaft to go with?
I have heard of/seen pot joints, hardy spicer etc.
I'm pretty sure I have 2 of the big ball bearing type that came with the car. Pot joints??

Also, I plan of going lsd when I build my gearbox.
What type of driveshaft/coupling is best for lsd purposes?

Just trying to get my head around driveshafts/diffs amongst other things!

Author:  TheMiniMan [ Wed Nov 30, 2011 4:05 pm ]
Post subject: 

yeah well , imo if you`1re going for the Quaife diff then Pottys are the go , concidering that it "Seems" you already have that set-up

Author:  coopar [ Wed Nov 30, 2011 4:49 pm ]
Post subject: 

Does using an a+ box pose any other problems?

Author:  TheMiniMan [ Wed Nov 30, 2011 4:57 pm ]
Post subject: 

no, not that i can see or think of, i reckon they~re pretty good actually

Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/