| ausmini https://www.ausmini.com/forums/ |
|
| Rod change box question https://www.ausmini.com/forums/viewtopic.php?f=2&t=75036 |
Page 1 of 1 |
| Author: | IndigoBlueCooperS [ Mon Jan 16, 2012 7:54 pm ] |
| Post subject: | Rod change box question |
Anyone had a rod change box where the little pin in the selector shaft is loose like the one on the right in the photo? Once assemble the pin is held in by the outer sleeve. This has not given me any problems. The box did about 5,000 miles like this. Just curious about other peoples experiences. 
|
|
| Author: | GT mowog [ Mon Jan 16, 2012 8:24 pm ] |
| Post subject: | |
Yeap, I've had a few like that. As long as it's not flopping about in the shaft, it'll be OK. |
|
| Author: | mickmini [ Tue Jan 17, 2012 12:31 pm ] |
| Post subject: | |
a drop of loctite will make it stay there |
|
| Author: | IndigoBlueCooperS [ Wed Jan 18, 2012 8:12 pm ] |
| Post subject: | |
Thanks for the info. I will put it back in with some loctite. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|