ausmini
https://www.ausmini.com/forums/

APT VP8 cam timing
https://www.ausmini.com/forums/viewtopic.php?f=2&t=75352		 Page 1 of 1
Author:  Beanie [ Sun Feb 05, 2012 1:17 pm ]
Post subject:  APT VP8 cam timing
Hi

Does anyone know the cam timing for this cam ... im trying to set one up at the moment , but i cant find any figures on it
its this camshaft here ..

http://www.aptfast.com/showitem.aspx?id ... 00.050%22&

Thanks Beanie
Author:  wobbles_55 [ Sun Feb 05, 2012 1:24 pm ]
Post subject:  Cam
Looked in the Yellow book???
Author:  Beanie [ Sun Feb 05, 2012 1:53 pm ]
Post subject: 
I have a white one not a yellow one
Author:  drmini in aust [ Sun Feb 05, 2012 1:56 pm ]
Post subject: 
Beanie wrote:
I have a white one not a yellow one

Yellow book says the VP8C is 102° LCA, IMO that's about where you would (conventionally) time it in at.
But the book doesn't specifically say.
Author:  Phat Kat [ Sun Feb 05, 2012 2:20 pm ]
Post subject: 
... you could always contact atp? :idea:

Also if its a cam that you've bought recently, what it says in the yellow book might not apply, they're proflies are constantly changing. I was looking at a VP3 about a year ago and the spec has changed since the yellow book was written.
Author:  Beanie [ Sun Feb 05, 2012 4:31 pm ]
Post subject: 
yeah if i had thought of it before i would have asked APT , but alas i didnt

Phone a friend who has the same Cam and paper work and it looks like 101.5 degrees is the go ..

cam is timed and engine is in the car ..
Time for a Beer

Beanie
Author:  pockets [ Tue Jul 04, 2017 6:34 pm ]
Post subject:  Re: APT VP8 cam timing
Has anybody got a dyno sheet showing how much TORQUE they got from an installed VP8C cam?
Author:  pockets [ Tue Jul 04, 2017 6:37 pm ]
Post subject:  Re: APT VP8 cam timing
Ditto an SPVP8-BK. Plus engine spec.
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/