[puts flameproof suit on]
Twin 1-1/4s go fine on a near stock 998, twin 1-1/2s are a little big.
Twins tend to give better torque and throttle response than a big single, I find. And, they look `right'
| ausmini https://www.ausmini.com/forums/ |
|
| Single or twin SU's? https://www.ausmini.com/forums/viewtopic.php?f=2&t=76183 |
Page 1 of 1 |
| Author: | Simo [ Sat Mar 31, 2012 1:38 pm ] |
| Post subject: | Single or twin SU's? |
Greetings all, Just looking for a bit of advice. Currently I have what I believe to be a fairly standard 998, with the addition of a single 1-3/4 SU carb and extractors. I've always liked the look of the twin SU set-up and was wondering what advantages/disadvantages there were if I was to change to say a twin 1-1/4 or 1-1/2 carb system. I know they are harder to tune to get the balance right, but I was wondering what other people had experienced with them. I not necessarily looking for massive power, just looking for the best setup for my engine. Cheers Simo |
|
| Author: | drmini in aust [ Sat Mar 31, 2012 1:55 pm ] |
| Post subject: | |
[puts flameproof suit on] Twin 1-1/4s go fine on a near stock 998, twin 1-1/2s are a little big. Twins tend to give better torque and throttle response than a big single, I find. And, they look `right'
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|