ausmini
https://www.ausmini.com/forums/

Would these fit my mini??? (pic inside)
https://www.ausmini.com/forums/viewtopic.php?f=2&t=7649		 Page 1 of 1
Author:  KiwiMR2 [ Sun May 29, 2005 8:23 pm ]
Post subject:  Would these fit my mini??? (pic inside)
I have a 1982 round nose....would these fit?? or are they from a later version mini? if they would fit I'll buy them tomorrow. According to the owner they came in a box from Aussie with some other mini bits....the only markings they have on them is 2626059

Image

Cheers
KiwiMR2
Author:  simon k [ Sun May 29, 2005 8:48 pm ]
Post subject: 
they're not normal aussie mini ones, get a picture from the other side - they need to have square holes, not splined
Author:  hutto [ Sun May 29, 2005 9:16 pm ]
Post subject: 
You could possibly stick a small round mini logo over the top of the screw, by the look in this picture, that would be pretty neat.
Author:  gafmo [ Sun May 29, 2005 9:34 pm ]
Post subject: 
I have not seen these before...Yer Sqaure hole on the Back :wink:
Author:  Metalfab_101 [ Mon May 30, 2005 4:04 pm ]
Post subject: 
Are these from a 1100 maybe?

I seem to recognise them, I think. I'm having flashbacks of being driven to school... :oops: :lol:

Or maybe they remind me of the XY falcon winders... sheesh, buggered if I know!!!
Author:  KiwiMR2 [ Mon May 30, 2005 5:46 pm ]
Post subject: 
I reakon I'll leave them aye....spend the money on some el glo dials for the MR2 :twisted:

Besides I should be heading to Japan in the next few months so should really be patience and wait till I get there to the Junk yards.

Cheers
KiwiMR2
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/