| ausmini https://www.ausmini.com/forums/ |
|
| DLI certified welder in/near Blue Mountains https://www.ausmini.com/forums/viewtopic.php?f=2&t=76955 |
Page 1 of 1 |
| Author: | Gareth_1330 [ Mon May 28, 2012 9:14 pm ] |
| Post subject: | DLI certified welder in/near Blue Mountains |
Looking for DLI certified welder in or near the blue mountains for a job on my project. I have narrowed the rear of a box section type chassis by by putting a pie cut on the inner rail and bending it in, and on an outer rail and bending it out. I intend to have this welded up and fish plated (i will cut the plates) My Engineer has said it has to be welded a DLI certified welder. I have the welder and whatnot, 250 amp MIG, just need someone to point it. Flick me a PM if your keen to make a bit of cash on the side |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|