simon k wrote:
pry bar...
This
Its how I got mine to fit
| ausmini https://www.ausmini.com/forums/ |
|
| Nothing is ever easy. https://www.ausmini.com/forums/viewtopic.php?f=2&t=77041 |
Page 1 of 1 |
| Author: | mini0998 [ Sun Jun 03, 2012 1:06 pm ] |
| Post subject: | Nothing is ever easy. |
Bolting the last few bits onto the 1275. The 1275 is rodchange compared to the old 998's remote shifter. Thought I better put the exhaust on before bolting up the shifter as it looked a very tight fit. Went to put the bolt in that holds the top shifter rod to the gearbox and I can't get the bolt in as the LCB extractors are in the way. I really don't wont to take off the carbies to move the exhaust back enough just to get that one bolt in, but unless someone has any ideas, it looks as though I will have to. |
|
| Author: | simon k [ Sun Jun 03, 2012 2:17 pm ] |
| Post subject: | |
pry bar... |
|
| Author: | PDJ [ Sun Jun 03, 2012 3:42 pm ] |
| Post subject: | |
simon k wrote: pry bar...
This Its how I got mine to fit
|
|
| Author: | dalmeny [ Sun Jun 03, 2012 3:55 pm ] |
| Post subject: | |
Stud with nuts on both ends. |
|
| Author: | mini0998 [ Sun Jun 03, 2012 5:11 pm ] |
| Post subject: | |
Couple of good tips, thanks. Will try the pry bar, might just get it. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|