ausmini https://www.ausmini.com/forums/
1.5 forged rockers https://www.ausmini.com/forums/viewtopic.php?f=2&t=77257	Page 1 of 1

---

Author:	Anto [ Thu Jun 21, 2012 3:09 pm ]
Post subject:	1.5 forged rockers
Does anyone have any opinion/experience/advice on these Mini spares rockers: http://www.minispares.com/product/Classic/Engine/Cylinder_heads/Rocker_Assemblies/C-AHT436.aspx?100407&ReturnUrl=/search/classic/rocker.aspx I might have an excuse to take the head of my engine soon, so was considering fitting a set for a few extra hp without outlaying too much cash on roller-tip rockers. Engine is a worked 1360 with 286md, so would probably appreciate some better rockers than the stock ones I'm running now

---

Author:	drmini in aust [ Thu Jun 21, 2012 3:52 pm ]
Post subject:
I've had a set of these on my 1360 for 50,000 miles now, no problems with them except they wore out the last cam I had in it (Camtech 619, aka VP3). The rocker pads and bronze bushes are still good, The bronze valve guides are still all good too.

---

Author:	Anto [ Thu Jun 21, 2012 3:59 pm ]
Post subject:
That's a positive then The car only does 2000 miles a year if I'm lucky, so longevity isn't a huge concern. Might have a think about also putting larger inlet valves in at the same time, still running stock ones

---

Page 1 of 1	All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/