ausmini
https://www.ausmini.com/forums/

orange dot clutch supply
https://www.ausmini.com/forums/viewtopic.php?f=2&t=77594		 Page 1 of 1
Author:  Kennomini [ Sat Jul 14, 2012 5:51 pm ]
Post subject:  orange dot clutch supply
I was looking at getting one from Karcraft but unfortunately they are out of stock for another 8 weeks.
So dose anyone else stock them?
Author:  MINImal effort [ Sat Jul 14, 2012 6:31 pm ]
Post subject: 
Most mini suppliers can probably help you out....
Online is Aus :
http://www.minis.com.au/minis/catalog/product_info.php?cPath=34&products_id=568

http://www.minisport.com.au/prod308.htm

..... sure theres more ...
:)
Author:  michaelb [ Sat Jul 14, 2012 9:19 pm ]
Post subject: 
Minispares UK can probably supply and usually takes a week for delivery
Author:  Kennomini [ Tue Jul 17, 2012 9:50 pm ]
Post subject: 
If I just get the orange dot pressure plate what clutch should I get?
Either a 8017, std replacment cooper S clutch?
or a AP racing heavie duty bonded cp2084-41 clutch?
Author:  drmini in aust [ Tue Jul 17, 2012 9:52 pm ]
Post subject: 
Kennomini wrote:
If I just get the orange dot pressure plate what clutch should I get?
Either a 8017, std replacment cooper S clutch?
or a AP racing heavie duty bonded cp2084-41 clutch?

The standard AP Cooper S etc one is fine for road cars, if racing I'd go the AP bonded and rivetted one.
Author:  Kennomini [ Tue Jul 17, 2012 10:02 pm ]
Post subject: 
Just to clarify it's for a 100+ bhp mini, daily driver that is driven hard.
What are the pros and cons to each clutch?
Author:  drmini in aust [ Tue Jul 17, 2012 10:08 pm ]
Post subject: 
The bonded & rivetted (rally etc) one is less likely to fly to bits if you give it a hard time. However as there's (maybe, was long ago, can't remember now) no springy bits in between the facings it could be more abrupt on bite than the std rivetted one.
Probably not a problem to you and me. :P
[edit] an orange dot diaphragm is fine for road use if it's N/A. Twinky even. :wink:

[edited] for clarity
Author:  simon k [ Tue Jul 17, 2012 10:08 pm ]
Post subject: 
I'm using a grey dot with normal "cooper s" clutch plate
Author:  Kennomini [ Wed Jul 18, 2012 6:45 pm ]
Post subject: 
Thanks everyone, time to go order some bits :) .
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/