| ausmini https://www.ausmini.com/forums/ |
|
| Match Porting an A series head. https://www.ausmini.com/forums/viewtopic.php?f=2&t=77682 |
Page 1 of 1 |
| Author: | 1380 K [ Thu Jul 19, 2012 8:36 pm ] |
| Post subject: | Match Porting an A series head. |
Anyone done this? Or heard experiences? David vizard says not to do it with the exhaust for certain reasons. But what about intake? Cheers |
|
| Author: | drmini in aust [ Thu Jul 19, 2012 9:24 pm ] |
| Post subject: | |
It does help to match the inlets, particularly when I've found one MiniSp**** inlet manifold so badly made that the 2 ports were over 3mm out of position! 
It was so bad I had to TIG weld one end of both flanges up, then re-mill the stud holes to align it. Then match port it to the head. |
|
| Author: | 1380 K [ Thu Jul 19, 2012 9:42 pm ] |
| Post subject: | |
Okay ill look into this cheers, Tom |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|