| ausmini https://www.ausmini.com/forums/ |
|
| moulds https://www.ausmini.com/forums/viewtopic.php?f=2&t=78183 |
Page 1 of 1 |
| Author: | ricksmini [ Sat Aug 25, 2012 6:26 pm ] |
| Post subject: | moulds |
hi all just wondering what is the best way to polish all of the mouldings on a mini for a great finish |
|
| Author: | John Smidt [ Sat Aug 25, 2012 6:48 pm ] |
| Post subject: | |
Most mouldings are stainless steel, so Autosolve or something similar is usually good or one of the stainless Polish they sell for kitchen sinks etc, |
|
| Author: | ricksmini [ Sat Aug 25, 2012 6:52 pm ] |
| Post subject: | |
Thanks John should I rub them down with some wet and dry first? |
|
| Author: | Convertible Mini [ Sat Aug 25, 2012 6:52 pm ] |
| Post subject: | polishing stainless |
Steelo pads. the soapy ones and water do a great job especially "before" putting chrome bits on the car. Try and rub away from paintwork. |
|
| Author: | John Smidt [ Sat Aug 25, 2012 7:03 pm ] |
| Post subject: | |
ricksmini wrote: Thanks John should I rub them down with some wet and dry first?
I dont use wet and dry I just use a good stainless polish, I always try to By Australian Made products, However in This area I find The German Made Products are The best. by a long way, I am not saying this because of My Sir Name ( My Sir Name is swedish Not German ) 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|