ausmini
https://www.ausmini.com/forums/

Need Help Getting some Seat Brackets made
https://www.ausmini.com/forums/viewtopic.php?f=2&t=78527		 Page 1 of 1
Author:  MrFail [ Tue Sep 18, 2012 3:38 pm ]
Post subject:  Need Help Getting some Seat Brackets made
i need some steel brackets made up and i am not sure where to go.
Does anyone either have the ability or know somewhere that can do them for me??.
Here's a pic of what i need.
I need 6 of these.. ( measurements are in mm).
Image
Author:  S_Squirel [ Tue Sep 18, 2012 3:53 pm ]
Post subject:  Brackets
Tim,

Correct me if im wrong but wouldnt they just be 40 x 40mm (5mm) equal angle cut at 25mm long?

Just ask the steel merchant to put them on the saw?

Shane
Author:  Harley [ Tue Sep 18, 2012 4:06 pm ]
Post subject: 
Yep, that is a standard size as 40 x 40 x 5 angle.
If you need the square edge, use 45 or 50 x 50 x 5 angle and cut the tips back.
Author:  MrFail [ Tue Sep 18, 2012 4:18 pm ]
Post subject: 
Oh, ok.
That should make it a bit easier.. :D

So if i just ring up a steel place, they should be able to help me out??
Author:  michaelb [ Tue Sep 18, 2012 7:48 pm ]
Post subject: 
And they will usually cut to your sizes and charge you a cutting fee
Author:  miniandrew [ Wed Sep 19, 2012 8:51 pm ]
Post subject: 
Brisbane Metal Market would be the go for this.... They are on the top end of moss st at springwood. One of the very few steel shops that do cut lengths these days. If not i might have some spare at work. :)
Author:  JC [ Wed Sep 19, 2012 9:43 pm ]
Post subject: 
Contact Archangel007. He had a heap of alloy seat brackets made up that may suit your needs.
Author:  MrFail [ Thu Sep 20, 2012 10:23 am ]
Post subject: 
Cool, thanks for the help guys
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/