| ausmini https://www.ausmini.com/forums/ |
|
| Indicator issue https://www.ausmini.com/forums/viewtopic.php?f=2&t=78573 |
Page 1 of 1 |
| Author: | NG [ Sat Sep 22, 2012 5:49 pm ] |
| Post subject: | Indicator issue |
My hazards work but my indicator stalk seems to Be dropping in and out? When turning left or right Finally now nothing. I sprayed a heap of contact Cleaner in there incase and it made the click sound once To the flasher then nothing. hazzards work dash lights work Any ideas? Is there a contact that wears inside the stalk? it's a rover stalk.maybe i m up for a new one? |
|
| Author: | d1ck0 [ Sat Sep 22, 2012 7:45 pm ] |
| Post subject: | |
Could be your flasher can (relay). They usually use a different one for indicators and hazards as the current draw is different. In saying that the 2 relays could be in the one housing. Cheers, Dicko. |
|
| Author: | VicMini13 [ Mon Sep 24, 2012 8:32 am ] |
| Post subject: | |
As Dicko says, in a Rover there are two flasher cans, one for the hazards and a separate one for the indicators. Before you ditch the indicator control arm, also check out the hazard switch - the indicator wiring goes from the control arm on the column to the hazard switch then off to the lights. The hazard switch is a double poll double throw that in the "on" position connects the hazard circuit to the lights but in the "off" position connects each indicator circuit to the lights. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|