Graham has the castings, and he machines them up when he has time.
Nobody else stocks them that I know of.
If he's not answering emails I'd ring him. Let the phone ring out for a bit- he's always working, not sitting on the phone...
| ausmini https://www.ausmini.com/forums/ |
|
| Graham Russell inlet manifold. https://www.ausmini.com/forums/viewtopic.php?f=2&t=78581 |
Page 1 of 1 |
| Author: | 1380 K [ Sun Sep 23, 2012 4:35 pm ] |
| Post subject: | Graham Russell inlet manifold. |
Hi just wondering if anyone could give me a rough idea of what these manifolds cost and where i could get one? ive email graham russell a couple times with no reply. Cheers |
|
| Author: | drmini in aust [ Sun Sep 23, 2012 4:51 pm ] |
| Post subject: | |
Graham has the castings, and he machines them up when he has time. Nobody else stocks them that I know of. If he's not answering emails I'd ring him. Let the phone ring out for a bit- he's always working, not sitting on the phone...
|
|
| Author: | 1380 K [ Sun Sep 23, 2012 5:26 pm ] |
| Post subject: | |
Righto will do. Thanks |
|
| Author: | TK [ Sun Sep 23, 2012 9:00 pm ] |
| Post subject: | |
Are you talking of the SU manifold? I run one but be careful it doesn't fit very well, well doesn't without mods. |
|
| Author: | Mokesta [ Sun Sep 23, 2012 9:12 pm ] |
| Post subject: | |
I have one in Brisbane. I believe it has had the carb mounting face modified to tilt the carb up to help clear the firewall. What are they worth? M |
|
| Author: | drmini in aust [ Sun Sep 23, 2012 9:41 pm ] |
| Post subject: | |
Mokesta wrote: I have one in Brisbane. I believe it has had the carb mounting face modified to tilt the carb up to help clear the firewall.
What are they worth? M I sold the one I had (which I machined myself) for $330 a year or so ago. I think new they were around $360 or so then, but that's a guess from what I remember. |
|
| Author: | Mokesta [ Sun Sep 23, 2012 10:02 pm ] |
| Post subject: | |
Same one I believe 
M |
|
| Author: | drmini in aust [ Mon Sep 24, 2012 9:06 am ] |
| Post subject: | |
I sold it (to a bloke in Tassie) because although the carb cleared the firewall there was no way I could fit any filter. And I refuse to run a road car without one. As I have a centre speedo I was not prepared to butcher the (roundy) body for a weber box, and if I had, the filter would have hit the speedo anyway. I then bought a Minispares manifold and fitted a 20mm spacer, then ported it inside for more volume & better flow. But it's still not as good as the GR one for power and torque. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|