Just so I get this right -
Doing the front ones.
Do I need to compress the cones, if I have hi-los, to replace these ?
Doing the front front shocks, engine mounts, and these in one hit.
| ausmini https://www.ausmini.com/forums/ |
|
| Top Arm - Ball / Cup replacement - Compress cones ? https://www.ausmini.com/forums/viewtopic.php?f=2&t=79076 |
Page 1 of 1 |
| Author: | Maxi23 [ Sun Nov 04, 2012 3:38 pm ] |
| Post subject: | Top Arm - Ball / Cup replacement - Compress cones ? |
Just so I get this right - Doing the front ones. Do I need to compress the cones, if I have hi-los, to replace these ?
Doing the front front shocks, engine mounts, and these in one hit. |
|
| Author: | miniDave [ Sun Nov 04, 2012 5:57 pm ] |
| Post subject: | |
I would say that for the fronts you will need to compress them. I have the compressor tool if you need it. 
|
|
| Author: | drmini in aust [ Sun Nov 04, 2012 6:13 pm ] |
| Post subject: | |
An alternative is take the top arms out, but using a compressor is much quicker. As long as there are still good threads in the cones... 
|
|
| Author: | Maxi23 [ Mon Nov 05, 2012 7:31 am ] |
| Post subject: | |
Thanks guys, I may borrow your compressor Dave. Knowing my luck the cone threads will be non existent....lol I will PM you once I have the parts. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|