That is the effect we are after, not sure if we want to keep the original look though. That would be for the boss to decide
| ausmini https://www.ausmini.com/forums/ |
|
| Seat construction https://www.ausmini.com/forums/viewtopic.php?f=2&t=79146 |
Page 1 of 1 |
| Author: | womble99 [ Sat Nov 10, 2012 7:00 pm ] |
| Post subject: | Seat construction |
Has anyone had experience with constructing seats? I have been surfing youtube to no avail. What I am looking for is how to make a custom seat (foam insert) using a standard mini seat frame (then obviously retrim). All I am aiming to do is add a little molding to the seat and back to be more conforming rather than just flat. |
|
| Author: | Kennomini [ Sat Nov 10, 2012 8:17 pm ] |
| Post subject: | |
When I had my high back Clubman seats re trimmed the trimmer used denser/harder foam on the edges of the back and base which keeps the seat looking fairly standard but when you sit in them you sink into the softer/standard foam in the middles of the seat and the harder foam up the edges acts like a bucket seat and works very well. |
|
| Author: | womble99 [ Sat Nov 10, 2012 8:51 pm ] |
| Post subject: | |
That is the effect we are after, not sure if we want to keep the original look though. That would be for the boss to decide
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|