need to roll them to get them out PIA job
bigger PIA to get hinges back
| ausmini https://www.ausmini.com/forums/ |
|
| 1970 ROUND NOSE WIPERS https://www.ausmini.com/forums/viewtopic.php?f=2&t=79244 |
Page 1 of 1 |
| Author: | Mozzie [ Tue Nov 20, 2012 1:34 pm ] |
| Post subject: | 1970 ROUND NOSE WIPERS |
OK, I'm removing the windscreen wiper wheel boxes and tube assy. I've disconnected the retaining nuts from the splines and removed the pipe from the motor/gearbox. I'm expecting the wiper wheel boxes and tube assy to drop back to the firewall but it only moves 1/2 inch or so. Any idea's on where to go from here.? I'm guessing the bonnet hinges have to be removed at the firewall? Thanks in advance for all suggestions. |
|
| Author: | frednutz&co [ Tue Nov 20, 2012 1:45 pm ] |
| Post subject: | |
need to roll them to get them out PIA job
bigger PIA to get hinges back
|
|
| Author: | slacko [ Tue Nov 20, 2012 6:54 pm ] |
| Post subject: | |
Just my opinion remove the bonnet from the hinges , not the hinges from the body there are brass washers in between each side of the hinge and the mounting slot on the body , trying to get them back in when reinstalling the hinges is a real pain in the butt Mark |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|