Hi guys, just a quick one, can anybody with a 13x7 wheel like a superlite, ultralite, etc please measure the inside diameter of the rim at the hub, and tell me what the wheel is, and offset if known?
Thats all I need. Thanks.
| ausmini https://www.ausmini.com/forums/ |
|
| Measuring request: 13x7 rim https://www.ausmini.com/forums/viewtopic.php?f=2&t=79434 |
Page 1 of 1 |
| Author: | Harley [ Wed Dec 05, 2012 12:36 pm ] |
| Post subject: | Measuring request: 13x7 rim |
Hi guys, just a quick one, can anybody with a 13x7 wheel like a superlite, ultralite, etc please measure the inside diameter of the rim at the hub, and tell me what the wheel is, and offset if known? Thats all I need. Thanks.
|
|
| Author: | michaelb [ Wed Dec 05, 2012 9:07 pm ] |
| Post subject: | |
You can measure mine on Sunday at Bundoora 
|
|
| Author: | Harley [ Wed Dec 05, 2012 9:26 pm ] |
| Post subject: | |
That might work! Thanks!
|
|
| Author: | dodge [ Thu Dec 06, 2012 12:14 pm ] |
| Post subject: | |
heres lots of measurements i just took from a set that i will be selling soon 13 x7 et -7 deep dish from the back of the hub( sits on the rotor or drum) to the rim edge inside 85 mm front of hub ( wheel nut location ) to edge of rim outside 90 mm inside dia of the rim 283 mm then steps out to 317 mm 40 mm at 283 to the step out anything else? yes selling 2 only brand new 13 x 7 
i ran narrow rear drums and cooper disc front, so i used 7 inch back and 6 inch fronts |
|
| Author: | Harley [ Thu Dec 06, 2012 12:35 pm ] |
| Post subject: | |
Dodge you're a legend! That's everything I could want to know. Very much appreciated! Thanks.
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|