| ausmini https://www.ausmini.com/forums/ |
|
| Wiper 12AUW round body https://www.ausmini.com/forums/viewtopic.php?f=2&t=80019 |
Page 1 of 1 |
| Author: | crisonic [ Sun Jan 20, 2013 3:26 pm ] |
| Post subject: | Wiper 12AUW round body |
I am rebuilding a 12AUW wiper - the round body one. Does anyone know what the gap should be between the wiper armature shaft and the adjusting screw? |
|
| Author: | drmini in aust [ Sun Jan 20, 2013 3:57 pm ] |
| Post subject: | |
It's not critical provided it doesn't bind. IMO .005" endfloat would be about right and would allow for expansion if it ever gets hot.. |
|
| Author: | crisonic [ Sun Jan 20, 2013 4:50 pm ] |
| Post subject: | Lucas 12AUW wiper motor |
Dear Doctor Thanks a mil I am on the way to the workshop to set it up |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|