| ausmini https://www.ausmini.com/forums/ |
|
| Electroplater in Sydney https://www.ausmini.com/forums/viewtopic.php?f=2&t=80086 |
Page 1 of 1 |
| Author: | michaelb [ Fri Jan 25, 2013 11:12 am ] |
| Post subject: | Electroplater in Sydney |
Looking for recommendations of electroplater in Sydney who can replate a bucket of bits and bolts. The place I have used previously only do individual parts by wire wrapping and are a bit expensive |
|
| Author: | XC9000 [ Fri Jan 25, 2013 12:31 pm ] |
| Post subject: | Chrome |
Enware are in Caringbah (Ned 9525 9511), but I havent had anything done there. Next time i will try them. Last I usedPioneer Plating (Tony 9734 6609 or 0433 356 482) at Liverpool with fair service, but BE WARNED, he never returns calls and rarely answers his mobile. Service 5/10 - work 8/10. |
|
| Author: | drmini in aust [ Fri Jan 25, 2013 12:44 pm ] |
| Post subject: | |
Try these guys, Elite Plating Address: 113 Woodpark Rd, Smithfield NSW 2164 Phone: (02) 9892 1692 They do barrel plating of zinc, either silver or gold finish. They go by weight. I've not used them but my mate Richard did recently. He said their pricing was good too. 
|
|
| Author: | John Smidt [ Fri Jan 25, 2013 12:54 pm ] |
| Post subject: | Re: Electroplater in Sydney |
michaelb wrote: Looking for recommendations of electroplater in Sydney who can replate a bucket of bits and bolts.
The place I have used previously only do individual parts by wire wrapping and are a bit expensive Try A & G Plating Pty Ltd Phone 02 97592848 These people do Barell plating, And that is what You Need I notice that they refer to it as Zinc Plating: Bright and Dichromate Bright = Blue Dichromate = orange ( in fact they are both dichromate finishes ) |
|
| Author: | michaelb [ Fri Jan 25, 2013 2:44 pm ] |
| Post subject: | |
Thanks John, you are the second person to advise of A&G at Belmore. |
|
| Author: | Boostedmini [ Sun Jan 27, 2013 7:44 am ] |
| Post subject: | |
Michael, Try Artarmon Electroplaters, I used them years ago as I did my apprenticeship over the road, they were pretty good. Grant |
|
| Author: | John Smidt [ Sun Jan 27, 2013 12:25 pm ] |
| Post subject: | |
Boostedmini wrote: Michael,
Try Artarmon Electroplaters, I used them years ago as I did my apprenticeship over the road, they were pretty good. Grant From what I understand they are very good at what they do, But I am told that they do not do barrel Plating, So ring them first to check |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|