What is the 1/4 threaded hole in the block heading towards the oil pump? Don't remember taking anything out.
| ausmini https://www.ausmini.com/forums/ |
|
| what is it? https://www.ausmini.com/forums/viewtopic.php?f=2&t=80103 |
Page 1 of 1 |
| Author: | dalmeny [ Sat Jan 26, 2013 6:51 pm ] |
| Post subject: | what is it? |
What is the 1/4 threaded hole in the block heading towards the oil pump? Don't remember taking anything out.
|
|
| Author: | Mick [ Sat Jan 26, 2013 7:22 pm ] |
| Post subject: | |
Don't worry about it, its not used for anything. It actually bottoms out at about an inch and a half. |
|
| Author: | dalmeny [ Sat Jan 26, 2013 7:26 pm ] |
| Post subject: | |
Mick wrote: Don't worry about it, its not used for anything. It actually bottoms out at about an inch and a half.
Thanks Mick. |
|
| Author: | sitnlo62 [ Sat Jan 26, 2013 7:57 pm ] |
| Post subject: | Re: what is it? |
dalmeny wrote: What is the 1/4 threaded hole in the block heading towards the oil pump? Don't remember taking anything out.
It is actually for a sump securing bolt when the Block is used in a conventional set up (North , South) with the gearbox behind the engine, Morris Minor, Midget Sprite ETC Dave |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|