Talked to Vic, and found out that in 74 they were Gold Zinc plated
Si I rubbed them back on a wire brush, and painted them last night.. See ausmini FB page for pic... lol
| ausmini https://www.ausmini.com/forums/ |
|
| The metal uprights.. What colour? https://www.ausmini.com/forums/viewtopic.php?f=2&t=80424 |
Page 1 of 1 |
| Author: | brett [ Tue Feb 19, 2013 11:50 pm ] |
| Post subject: | The metal uprights.. What colour? |
http://www.minisport.com.au/prod1610.htm On the Leylands what was the colour of the uprights? that these bolt to? CHeers Brett |
|
| Author: | Bubbacluby [ Wed Feb 20, 2013 7:09 am ] |
| Post subject: | |
silver Alloy colour Some were cast though, and as far I believe these usually went rusty like the clutch slave cylinder. If it were me I would blast it then stick some clear on them so they didnt go rusty. Im not sure when cast ones came in and exited? |
|
| Author: | brett [ Fri Feb 22, 2013 2:25 pm ] |
| Post subject: | |
Talked to Vic, and found out that in 74 they were Gold Zinc plated
Si I rubbed them back on a wire brush, and painted them last night.. See ausmini FB page for pic... lol |
|
| Author: | Mick [ Sat Feb 23, 2013 3:08 pm ] |
| Post subject: | |
Oops, wrong parts...soz |
|
| Author: | Bubbacluby [ Sat Feb 23, 2013 4:55 pm ] |
| Post subject: | |
brett wrote: Talked to Vic, and found out that in 74 they were Gold Zinc plated
Si I rubbed them back on a wire brush, and painted them last night.. See ausmini FB page for pic... lol Hmmm... ok I have never seen them gold.... Which Vic is this? I still put money on the cast ones being not coated in anything, |
|
| Author: | brett [ Sat Feb 23, 2013 5:42 pm ] |
| Post subject: | |
At mini performance in Sydney. He seems to have lots of nos stuff I pulled mine out, there seems to have been some gold stuff on mine.. inc the little spacers |
|
| Author: | John Smidt [ Sat Feb 23, 2013 7:44 pm ] |
| Post subject: | |
brett wrote: At mini performance in Sydney. He seems to have lots of nos stuff I pulled mine out, there seems to have been some gold stuff on mine.. inc the little spacers
They May be Recon units, I must say I have not seen These plated from the factory, that is If we are talking about the master cylinder that is fitted with the plastic containers You mentioned |
|
| Author: | brett [ Sat Feb 23, 2013 8:36 pm ] |
| Post subject: | |
oh ok.. Perhaps he was wrong...  Well they are a nice Gold colour now...
|
|
| Author: | Bubbacluby [ Sat Feb 23, 2013 9:30 pm ] |
| Post subject: | |
brett wrote: oh ok.. Perhaps he was wrong...
Well they are a nice Gold colour now...related: You said you painted them... I assume so they would look like gold zinc. What did you use? |
|
| Author: | Timbo [ Sun Feb 24, 2013 6:00 am ] |
| Post subject: | |
And how will you stop the brake fluid stripping it off? Tim |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|