| ausmini https://www.ausmini.com/forums/ |
|
| 12g 949 1275 block id https://www.ausmini.com/forums/viewtopic.php?f=2&t=80533 |
Page 1 of 1 |
| Author: | FNQ [ Fri Mar 01, 2013 8:14 pm ] |
| Post subject: | 12g 949 1275 block id |
Is this block number related to inline 1275 motor? http://www.gumtree.com.au/s-ad/north-ward/engine-engine-parts-transmission/mini-1275-block/1014362193 |
|
| Author: | drmini in aust [ Fri Mar 01, 2013 8:25 pm ] |
| Post subject: | |
It's just a thin flange 1275 block. Could be either an 1100S or an MG Midget. Same casting number. An inline block will work in a Mini. The only mod is to machine the rear main bearing cap's oil return off so it's flat like a Mini one. Of course you need a transverse 1275 crank to use in it. I'd grab it for $200 if you need a block. |
|
| Author: | sitnlo62 [ Sat Mar 02, 2013 7:21 am ] |
| Post subject: | |
Looking at the Photo, the fact that it has those 2 Short Studs in the Sump rail indicate that it is more likeky to be from an 1100S (1275) originally. Dave |
|
| Author: | FNQ [ Sat Mar 02, 2013 4:02 pm ] |
| Post subject: | |
thank you - good eyes there. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|