ausmini
https://www.ausmini.com/forums/

Printed circuits?
https://www.ausmini.com/forums/viewtopic.php?f=2&t=80828		 Page 1 of 1
Author:  Paddy [ Sun Mar 24, 2013 4:14 pm ]
Post subject:  Printed circuits?
Hey again, been having a busy weekend on the mini, thanks for the help so far. next up i am looking at replacing the printed circuit on the back of the gauges, i have pulled it out but it doesnt seem to match any of the ones on minisport. could someone please help identify which one i have and/or which one i need.

the one i have
Image
the front so you know which gauges i have (its upside down to keep the gauges on the correct side)
Image
the minisport one that is closest one i could find
http://www.minisport.com.au/prod1794.htm

it seems to be about 80% right except for the bit on the left around the tacho. any help would be much appreciated.
Author:  Convertible Mini [ Sun Mar 24, 2013 5:06 pm ]
Post subject:  Flex Printed circuits.
I now also have these correct Printed circuits for these Clusters which are also used on Clubman GT.. PM sent.
Author:  9YaTaH [ Sun Mar 24, 2013 7:38 pm ]
Post subject: 
The PCB looks to be in good condition...why change it??? :D
Author:  Paddy [ Sun Mar 24, 2013 8:40 pm ]
Post subject: 
It's hard to see in the photo but the section between the tachometer and fuel/temp gauges ( top left in photo ) has been bent to many times and has broken the connections
Author:  9YaTaH [ Sun Mar 24, 2013 10:05 pm ]
Post subject: 
Paddy wrote:
It's hard to see in the photo but the section between the tachometer and fuel/temp gauges ( top left in photo ) has been bent to many times and has broken the connections


Ohh? OK....but you can just gently remove the conformal coating and solder (using say some multi=strand braid or wire) then spray or paint with a protective coating :idea:
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/