| ausmini https://www.ausmini.com/forums/ |
|
| under body sound deadener https://www.ausmini.com/forums/viewtopic.php?f=2&t=81683 |
Page 1 of 1 |
| Author: | junior [ Tue Jun 04, 2013 2:59 pm ] |
| Post subject: | under body sound deadener |
Are there specific areas that under body sound deadener was applied or excluded from? |
|
| Author: | drmini in aust [ Tue Jun 04, 2013 3:02 pm ] |
| Post subject: | |
It was pretty much applied stem to stern, including the wheel arches. But not that vertical face of the sills (below the chrome strip). Was done before subframes were fitted. |
|
| Author: | junior [ Tue Jun 04, 2013 3:54 pm ] |
| Post subject: | |
cheers, I assume the tunnel was also done then. How far up in the fire wall did it go, under the steering rack mount or under the bulk head |
|
| Author: | drmini in aust [ Tue Jun 04, 2013 4:49 pm ] |
| Post subject: | |
Up to the underside of bulkhead I think. |
|
| Author: | Monaco [ Tue Jun 04, 2013 6:22 pm ] |
| Post subject: | |
Was it painted body colour or natural grey/black? |
|
| Author: | brett [ Tue Jun 04, 2013 6:28 pm ] |
| Post subject: | |
It was body coloured, there was a certain brand used, and gives the smoothish leathery finish, not the crap that you see applied to that looks a bit like stucco. |
|
| Author: | peterb [ Tue Jun 04, 2013 7:57 pm ] |
| Post subject: | |
This is good stuff, if it holds rusty UK mini's together it must be. I used it on mine, sticks like sh*t and tough. Plus you can paint straight over it, don't overdo the paint but, otherwise the paint will chip off tex coat. http://www.hex.co.uk/tds/upol/gravitex.pdf |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|