ausmini
https://www.ausmini.com/forums/

Rear hi-lo ball and cup boot
https://www.ausmini.com/forums/viewtopic.php?f=2&t=81965
Page 1 of 1

Author:  _666_ [ Tue Jul 02, 2013 11:21 am ]
Post subject:  Rear hi-lo ball and cup boot

while installing my rear hi-lo's and cones, the boot for my ball and cup has slipped off the cup, and is next to impossible to get into to flip back over the cup,

does it need to be there ?

Nick

Author:  Ian49 [ Tue Jul 02, 2013 12:03 pm ]
Post subject: 

No need to compress rear cones. Once shockers are removed rear arm will swing enough to unload cones allowing removal.

Author:  Harley [ Tue Jul 02, 2013 2:37 pm ]
Post subject: 

The boot does need to be there, otherwise dirt and grit will get in and quickly wear out the plastic cup.
I'd just back the hilos right off, get the shaft out and see if you can get the boot back on that way.

Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/