ausmini
https://www.ausmini.com/forums/

Smiths Oil temp mechanical install
https://www.ausmini.com/forums/viewtopic.php?f=2&t=82200		 Page 1 of 1
Author:  davem [ Thu Jul 25, 2013 6:56 pm ]
Post subject:  Smiths Oil temp mechanical install
Noob question, can anyone show me a pic of where is an appropriate place to plumb in my gauge on the engine block 1100s and the correct fitting, l would rather not use the sump. Thanks for any help.
Author:  MORRIS COOPER S 501 [ Thu Jul 25, 2013 7:09 pm ]
Post subject: 
Image

the braided silver line that runs over the booster to the block

Image

same spot black line
Author:  drmini in aust [ Thu Jul 25, 2013 7:28 pm ]
Post subject: 
Those 2 pics ^^ are oil pressure lines, he wants oil TEMP.
I would put it on the block to filter oil line somehow, just make up a brass fitting.
Author:  MORRIS COOPER S 501 [ Thu Jul 25, 2013 7:41 pm ]
Post subject: 
Image
:oops: gearbox photo, but as you said he wants fitment to the block
drmini in aust wrote:
Quote:
Those 2 pics ^^ are oil pressure lines, he wants oil TEMP.
I would put it on the block to filter oil line somehow, just make up a brass fitting.
Author:  MORRIS COOPER S 501 [ Thu Jul 25, 2013 7:52 pm ]
Post subject: 
Image

Also found this fitment

Image
Author:  drmini in aust [ Thu Jul 25, 2013 7:55 pm ]
Post subject: 
That looks good, easy to make too if unavailable here.
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/